GesslerEZF WIKIKNOWLEDGE HUB
PLDEEN

AirBUS: luminaire transmit power and SEND SYNC

RADIO · STEP BY STEP

AirBUS: luminaire transmit power and SEND SYNC

480 × 320 display screens in the selected language. The yellow outline marks where to tap. Illustrated data is for demonstration.

Display interface
Before you start

Have your own administrator or service PIN and the required luminaire radio power ready. The luminaires must have power and be reachable by radio to receive synchronization. After saving, you will also run Send SYNC in the Radio menu. Controller access codes →

  1. EZF480 × 320 · Classic
    Step 1: Open MENU
    1Step 1 / 8

    Open MENU

    On the home screen, tap MENU in the upper right. If prompted, enter your own PIN and confirm with OK. Controller access codes →

  2. EZF480 × 320 · Classic
    Step 2: Open the second menu page
    2Step 2 / 8

    Open the second menu page

    Tap the right arrow in the top bar.

  3. EZF480 × 320 · Classic
    Step 3: Choose “Settings”
    3Step 3 / 8

    Choose “Settings”

    On the second menu page, tap Settings in the lower left.

  4. EZF480 × 320 · Classic
    Step 4: Open “Radio”
    4Step 4 / 8

    Open “Radio”

    On the first settings page, tap Radio in the lower right.

  5. EZF480 × 320 · Classic
    Step 5: Choose “In lumin.”
    5Step 5 / 8

    Choose “In lumin.”

    In the Radio menu, tap In lumin. in the upper right. This opens the shared radio power setting for AirBUS luminaires.

  6. EZF480 × 320 · Classic
    Step 6: Choose the luminaire transmit power
    6Step 6 / 8

    Choose the luminaire transmit power

    Tap the required positive dBm value in the two upper columns. A higher level increases power; a lower level reduces it. Example: +12 → +14 dBm. Available: +3, +6, +9, +12, +14, +16, +18, +20 dBm. The lower −085 dBm value is a separate RSSI threshold; the lower −/+ buttons adjust that threshold, not transmit power.

  7. EZF480 × 320 · Classic
    Step 7: Save luminaire power with the disk icon
    7Step 7 / 8

    Save luminaire power with the disk icon

    Tap the disk icon in the upper left. The controller saves the setting and returns to the Radio menu. The next step — Send SYNC — is required to transmit the setting to the luminaires.

  8. EZF480 × 320 · Classic
    Step 8: Run “Send SYNC”
    8Step 8 / 8

    Run “Send SYNC”

    After saving, tap the yellow-outlined Send SYNC tile. This is the additional menu action required for the luminaires. The controller requests radio synchronization with the saved power level. There is no additional confirmation dialog.

Finish and verify

After running Send SYNC, allow the network to synchronize. Reopen In lumin. to check the saved level. The highlighted value shows the setting stored in the controller; tapping SYNC does not confirm receipt by every luminaire.

Other radio guidesRadio: controller transmit power →