Delete the entire Wireless channel list, with both confirmation screens.
1 min readUpdated: 2026-11-06
AIRBUS · STEP BY STEP
AirBUS: delete all luminaires
480 × 320 display screens in the selected language. The yellow outline marks where to tap. Illustrated data is for demonstration.
Display interface
Before you start
This operation deletes the entire AirBUS list and current AirBUS test group states/results. Export the list and any required reports before starting. Do not use it to remove just one luminaire.
If the controller asks for a PIN
Enter your own PIN on the display keypad and confirm with OK. Use an account authorised for the operation. If already signed in, continue to the next menu screen. Controller access codes →
On the home screen, tap the menu icon in the upper right. If a PIN keypad appears, sign in with access to luminaire management. Controller access codes →
EZF480 × 320 · Classic
2Step 2 / 6
Choose “Luminaires”
Stay on the first menu page and tap the luminaires tile in the upper right.
EZF480 × 320 · Classic
3Step 3 / 6
Tap “Remove all”
Tap the middle tile in the upper row. This is a separate action for all luminaires on the selected channel.
EZF480 × 320 · Classic
4Step 4 / 6
Choose “Wireless” — AirBUS
Tap Wireless on the left. This guide applies to the AirBUS radio channel. Do not select BUS1 or BUS2.
EZF480 × 320 · Classic
5Step 5 / 6
Press Delete on the question screen
On the screen asking about deleting all luminaires, press Delete in the lower right. A final confirmation follows. To stop, use the back arrow.
EZF480 × 320 · Classic
6Step 6 / 6
Confirm “Are you sure?”
OK on the right confirms deleting the entire AirBUS list. If you do not intend to remove every entry on this channel, press Cancel.
Finish and verify
Wait for completion and check that the AirBUS list is empty. Selecting Wireless does not delete BUS1/BUS2 lists. The controller also broadcasts a delete-all command by radio. To resume monitoring, add the luminaires and check test settings.
Export the current luminaire list and any required reports. This action affects the entire AirBUS list and clears current AirBUS test group states/results. Use single deletion for just one luminaire.
Display sequence
Open MENU → Luminaires → Remove all.
Choose Wireless. This selects the AirBUS channel.
On the screen asking about deleting all luminaires, press Delete in the lower right.
Confirm the additional safety question with OK on the right, or use Cancel to abort.
Wait for completion and check that the AirBUS list is empty.
Scope
Local AirBUS entries and current test data for this channel are cleared. The controller also broadcasts a delete-all command by radio. Selecting Wireless does not delete BUS1/BUS2 lists.
To resume monitoring, add the luminaires again and check their configuration and test settings. This is neither a reset of the whole controller nor deletion of a single address.
