Enable the controller’s own Wi‑Fi network and read connection details in INFO.
1 min readUpdated: 2026-11-06
NETWORK AND EMAIL · STEP BY STEP
Switch the interface to Access Point
480 × 320 display screens in the selected language. The yellow outline marks where to tap. Illustrated data is for demonstration.
Display interface
Before you start
AP mode creates the controller’s local Wi‑Fi network. It does not itself provide Internet for cloud services or email alerts. Afterwards, connect the phone or computer to the controller’s network.
If the controller asks for a PIN
Enter your PIN on the display and confirm with OK. Use an account authorised for settings. Email CLOUD requires Administrator or Service access. If already signed in, continue to the next menu screen. Controller access codes →
Tap MENU in the upper right. If the PIN keypad appears, enter your own code and confirm with OK. Use an account authorised to configure the controller. Controller access codes →
EZF480 × 320 · Classic
2Step 2 / 10
Open the second menu page
Tap the right arrow in the top bar.
EZF480 × 320 · Classic
3Step 3 / 10
Open “Settings”
Choose the Settings tile in the lower left.
EZF480 × 320 · Classic
4Step 4 / 10
Open “Network”
Choose the middle tile with the network icon in the upper row.
EZF480 × 320 · Classic
5Step 5 / 10
Open “Interface”
Use the upper-left tile to choose the connection type. The other tiles depend on the active profile.
EZF480 × 320 · Classic
6Step 6 / 10
Choose the right Access Point icon
Tap the right access point icon. The controller will create its own Wi‑Fi network for local connections.
EZF480 × 320 · Classic
7Step 7 / 10
Save the selected interface
After selecting a mode, a floppy-disk icon appears in the upper left. Tap it. Selecting the mode alone does not save the change.
EZF480 × 320 · Classic
8Step 8 / 10
Confirm saving and restart
Confirm the save-changes question with OK on the right. The controller saves the profile and restarts. The previous network connection is disconnected.
EZF480 × 320 · Classic
9Step 9 / 10
Open INFO after restart
Tap INFO in the upper left of the home screen.
EZF480 × 320 · Classic
10Step 10 / 10
Read the controller AP connection details
After restart, return home and open INFO. In AP mode it shows SSID, PASS and the current IP address. Connect a phone or computer using your controller’s own details. The illustration contains demonstration data only.
Finish and verify
Read the actual IP address in INFO and use it for the local connection. AP credentials are device-specific; do not use the illustrated password. This display menu does not edit the AP SSID/password or AP DHCP/IP.
On the second page, choose Settings → Network → Interface.
Choose the right Access Point icon.
Tap the floppy-disk icon, confirm saving with OK on the right and wait for restart.
Open INFO on the home screen and read your controller’s SSID, PASS and actual IP address.
Connect a phone or computer to this network and use the displayed IP address.
Differences
AP creates a local network; it does not join a router like Wi‑Fi client mode. AP alone does not provide Internet for cloud services or email alerts. SSID and password are device-specific. Images show demonstration data, not a universal password.
In AP mode the Network menu does not offer DHCP/IP editing, client settings or network scanning. There is no AP SSID/password editor here. Read the current IP in INFO instead of assuming an example value.
