Network — switch from Wi‑Fi client to LAN

Select wired LAN, save the profile and restart the controller.

1 min readUpdated: 2026-11-06

NETWORK AND EMAIL · STEP BY STEP

Switch from Wi‑Fi client to LAN

480 × 320 display screens in the selected language. The yellow outline marks where to tap. Illustrated data is for demonstration.

Display interface

Before you start

Connect an Ethernet cable to the controller and local network. Have address settings ready if DHCP is not used. Changing interface requires a restart and ends the existing Wi‑Fi connection.

If the controller asks for a PIN

Enter your PIN on the display and confirm with OK. Use an account authorised for settings. Email CLOUD requires Administrator or Service access. If already signed in, continue to the next menu screen. Controller access codes →

In METRO, the PIN window retains its original appearance. Controller access codes →

EZF480 × 320 · Classic

EZF480 × 320 · Classic

1Step 1 / 8
Open MENU
Tap MENU in the upper right. If the PIN keypad appears, enter your own code and confirm with OK. Use an account authorised to configure the controller. Controller access codes →
EZF480 × 320 · Classic

2Step 2 / 8
Open the second menu page
Tap the right arrow in the top bar.
EZF480 × 320 · Classic

3Step 3 / 8
Open “Settings”
Choose the Settings tile in the lower left.
EZF480 × 320 · Classic

4Step 4 / 8
Open “Network”
Choose the middle tile with the network icon in the upper row.
EZF480 × 320 · Classic

5Step 5 / 8
Open “Interface”
Use the upper-left tile to choose the connection type. The other tiles depend on the active profile.
EZF480 × 320 · Classic

6Step 6 / 8
Choose the left LAN icon
Tap the left network connector icon. Connect an Ethernet cable between the controller and the local network.
EZF480 × 320 · Classic

7Step 7 / 8
Save the selected interface
After selecting a mode, a floppy-disk icon appears in the upper left. Tap it. Selecting the mode alone does not save the change.
EZF480 × 320 · Classic

8Step 8 / 8
Confirm saving and restart
Confirm the save-changes question with OK on the right. The controller saves the profile and restarts. The previous network connection is disconnected.

Finish and verify

After restart, the controller uses LAN. Check the cable and actual IP address in Information. For a static address, reopen Network → DHCP and set the LAN IP, gateway and subnet mask.

Other network and email guides

Wi‑Fi client: select and scan networks →Switch the interface to Access Point →DHCP or static IP address →CLOUD email notifications: setup and test →

Switch interface

Open the illustrated display guide.

Connect the Ethernet cable.
Open MENU, enter your PIN if prompted and use the right arrow to reach Settings → Network. Controller access codes →
Choose Interface and the left LAN icon.
Tap the floppy-disk icon in the upper left.
Confirm the save question with OK. The controller saves the profile and restarts.
Check the IP address in Information and reconnect through the correct network.

Tapping the mode icon alone does not finish the change; save and confirmation are required. In LAN mode the controller uses the wired interface instead of the Wi‑Fi client. LAN has its own DHCP/static address profile. Set a static IP address separately after selecting LAN.

EZF Wiki · Wiedza pod ręką.

Network — switch from Wi‑Fi client to LAN

Open MENU

Open the second menu page

Open “Settings”

Open “Network”

Open “Interface”

Choose the left LAN icon

Save the selected interface

Confirm saving and restart

Switch interface

In the same subject area.

Network — Wi‑Fi client setup and network scanning

Network — controller Access Point mode

Network — DHCP and static IP configuration